#1 in the market to support High Capacity Card & the first to launch USB 3.0 port

Images: 1 , 2 , 3

Model#  i18-C38

USB 2.0 Internal Card Reader

3.5" Bay with Black Panel


  • Support the latest High Speed / High Capacity Flash Memory Card Up to 32GB (SDHC 2.0 Compliance)
  • Support SuperSpeed USB 3.0 X 1 port
  • Support the latest flash card specification: CF 4.0 (DMA mode), SD1.1/2.0 (SDHC), MMC4.1/4.2, MSPro parallel mode (4-bit), xD 1.2
  • Support all e-SATA External Hard Drive
  • Extra USB 2.0 port
  • Internal design fitting into 3.5" drive bay to save the desktop space.
  • Supports Hot-Swapping and Plug and Play function.
  • Support slot-to-slot read/write operation
  • USB Bus powered; no external power required.
  • Support USB V2.0 specification and USB Device Class Definition for Mass Storage, Bulk-Transport
  • Support Win ME/2000/XP/Vista/Win 7/8, Mac OS X/ V9.2 or higher
  • Driverless
  • All internal cable with direct connection to motherboard onboard port

i18-C38 port layout picture


  • 5 Slots USB 2.0 Speed Card Reader
  • Front USB & eSATA (all must be connected to motherboard onboard ports)
  • Transfer rate of Hi-Speed USB 2.0 interface
  • Reader and Writer Support :
  • CF I,CF II,Extreme CF,Extreme III CF,Ultra II CF,HS CF, Micro Drive

  • Secure Digital Card,Mini SD, Extreme SD, Extreme III SD,Ultra II SD


  • xD - Picture

  • MS, MS Pro, MS Magic Gate, MS-Pro Magic Gate,HS-MS-Pro Magic Gate, MS-DUO, MS Pro-Duo, MS Pro-Duo PSP, MS Pro-Duo Gaming, HS-MS-Pro Duo,MS-DUO MagicGate, MS Pro-DUO MagicGate

  • USB Disk or other

Installation Quick Guide
  • Simply plug the USB cable to your motherboard, match the Red wire to your board manual +5V pin; or the black wire to the Ground pin
  • Connect the SATA cable to your onboard SATA port (Sample picture 3)
  • i18-C38 comes in two USB connectors; a 4 pin (onboard) USB connector and a 20 pins USB 3.0 internal connector; plug the 4 pin internal USB connector header to your onboard USB 2.0 & USB 3.0 onboard port by following above step  (see Sample picture 2)
  • Check your BIOS setting to see if you need to "Enable USB Device"

Sample picture 1

Sample picture 2

  • Connect SATA Port

Sample picture 3

  • USB 3.0 cable connection

(i18-C38) Package Contents

  • All-in-1 Card Reader
  • SATA cable (Internal)
  • USB 2.0 Cables (Internal)
  • USB 3.0 Cable (Internal)
  • Screws
  • User Guide

Go back  Top

About nMedia   Contact Us  Legal Disclaimer

Copyright ©  2005-2013 NMEDIA SYSTEM, INC. All Rights Reserved.